Tips For Successful Concrete Piles Installation

Concrete Piles installation is a complex job that requires some planning. If you want your driveway or garage to last for years to come, then concrete piles installation is a project that you should be willing to take on yourself. Before you begin digging out your new driveway, garage or basement however, you need to make sure you are prepared to handle the job with the utmost professionalism and safety ep coc be tong .

You first need to prepare for the concrete piles installation by locating the correct place for your concrete pile. This means knowing where to put it so it will be straight and leveled properly as well as being in a safe and level position. While you can usually buy pre-made concrete aggregates at your local hardware store or home improvement store, if you are going to be using concrete bricks, you will need to dig holes of at least three feet deep and make certain they are the right size and depth for the job you are about to undertake. The smaller the hole the less time it will take to set up the concrete pile and the more efficient the project will be.

What is a precast concrete pile - craftingwithconcrete.com

Once you have located the correct spot, it is time to line out your site so you know where to put each of the concrete pails. A good way to keep yourself organized and make sure you do not miss a section of concrete, is to draw a plan out on graph paper. This will help you see everything that you will need to know before you get started. Having a well laid out and clear path ahead of you will save you a lot of time and make the project go faster.

Once you have drawn your plan, then you are ready to start digging. Depending on the size of the hole you have dug, you may need to backfill around the site to keep water away from the concrete pails. Backfilling is done by pouring concrete into the hole and then trowing it out later. Make sure you only put in enough concrete to completely cover the area you have dug. If you pour too much concrete, you will flood and if you put in too little concrete it will just sit there and dry.

Once you have finished digging, it is time to put up your concrete pile. You should place the assembled concrete pails inside the hole you just dug and secure with steel ties or something similar. Make sure that when you set up the concrete piles, the holes you have dug are exactly equal in size.

When the concrete pails are assembled and secured, pour the concrete into them one at a time. Make sure to spread them out evenly, but try to have them lie parallel to each other. After they are fully loaded, you can now stand back and look at your newly built concrete pile. In no time at all, you will have a perfect DIY concrete wall or concrete floor for your home.

Leave a comment

Your email address will not be published. Required fields are marked *